Results From Real Plant Trials
Every recommendation we make is proved on the customer's own line. These are the outcomes they measured.
A trial starts with a sample part, agreed pass/fail criteria and an engineer on site. The results below are as reported by the plants that ran them — defect rates, solvent elimination and process consolidation, measured against what the line was doing before.
White-rust defects cut from 3.2% to 0.4%
After switching to POWER CLEAN LF-59 for ADC12 engine housings, a major automotive OEM in Bengaluru saw white-rust defects fall from 3.2% to 0.4% within 45 days.
20% faster cycle time on a spray tunnel
A home-appliance components supplier running 6000-series aluminium extrusions achieved 20% faster cycle time with POWER CLEAN LF-59 in low-foam mode — turnaround improved and re-works dropped.
One bath for aluminium, brass and copper
An export-focused precision components house now runs aluminium, brass and copper parts in the same bath: one process for all non-ferrous work, less downtime and a lower cost per part.
Flash rust eliminated before plating
A TVS Group sub-vendor had corrosion appearing on mild and carbon steel parts after ultrasonic cleaning. With POWER CLEAN SP the parts now hold with no rust for more than 12 hours before plating.
Proved Before You Commit
- 1Send a sample partWith a description of the soil, the substrate and the wash equipment it runs through today.
- 2The lab matches a formulationSubstrate and soil compatibility are tested on your actual component before anything is recommended.
- 3Agree pass/fail up frontCleanliness standard, cycle time and cost target are set before the trial, not argued afterwards.
- 4Run it on your own lineSupervised, from a 20 L pail, on your equipment. You move forward only if the numbers clear the bar.
Bring Us Your Hardest Cleaning Problem
Send a sample part or describe your process — our lab replies with a matched approach and measurable criteria.
Prefer to talk? Call +91-9731727868WhatsApp us